Indonesia Rubber Wood Factory Cuts Mold Risk with High-Humidity Wood Veneer Dryer

Medan, Indonesia – Southeast Asia Timber Processing NewsAn Indonesia rubber wood processing factory installed a new wood veneer dryer to solve veneer mold and re-absorption problems caused by tropical high humidity. The region has heavy rainfall and high air humidity all year round. Freshly peeled rubber wood veneer carries very high initial moisture, and the original wood dryer could not remove internal moisture thoroughly. The outdated drying machine often only dried the veneer surface, and hidden moisture triggered mold after stacking.

The factory produces rubber wood veneer for indoor furniture and door skin panels. Buyers from Singapore and Australia have strict requirements on mold resistance and veneer stability. The customer tried adjusting manual operation parameters many times, but the old drying machine lacked active dehumidification functions. Therefore, they chose a professional wood veneer dryer built for tropical high-humidity workshops.

This upgraded wood veneer dryer adopts dual-circulation hot air and automatic vapor exhaust design. While the drying machine heats the veneer evenly, it discharges water vapor out of the chamber in time to avoid secondary moisture regain. Operators can store dedicated rubber wood drying recipes inside the wood veneer dryer control panel. The optimized air duct layout eliminates dead corners, so hot air touches both sides of each veneer sheet. Compared with the old wood dryer, this wood veneer dryer shortens the whole drying cycle.

Since the wood veneer dryer was put into full load, veneer mold incidents have almost disappeared. The qualified rate of veneer rose to 97.5%. The stable drying machine performance helps the factory keep a stable supply to buyers in Southeast Asia and Oceania. The customer also benefits from the waste heat recovery module of the wood veneer dryer, which lowers monthly fuel cost significantly.